Plumbing repair service san fernando valley - Quick primer on Plumbing services - Home - Home Security

Sewage backup cleanup simi valley : Used principally for warm and cold water lines within the house the best tool to cut rigid copper tubinga€™s and pipe cutter. The pipe is placed withing the cutter and the knob is turned down which brings the pipe into contact with the cutter wheel as the cutter is rotated around pipe, you continue to tighten the wheel, until you have cut through the complete pipe. There are two ways to connect copper pipes the first is to solder or sweat the pipes together. The second is the use of compression fittings.

Soldered fittings are much less expensive then the compression but take a little a small degree more work to form a leak free joint. When you sweat copper pipes the first thing is to clean the ends that you are going to sweat along. Then flux is applied to both the pipe and therefore the fitting connecting to it. The pieces are placed along and warmth is applied to the union with a propane torch.

Planning to sweat together the flux is applied to both the pipe and therefore fitting you are connecting to it. The pieces are placed together and heat is applied to the union with a propane torch. When the union is heated enough, the solder is applied to join the solder is sucked into the joint sealing the 2 items together. From experience, I can tell you take to make this work successfully. There must be absolute no water in the line, if there is the joint leak. And once a joint leaks there is no repairs without replacing the fitting and starting over.

Professional plumbers tend to use a hotter source of heat, then the propane bottle can provide. But I am always continuously concerned about using any heat source inside my house. If you choose this method be very careful with the torch in tight spaces it might be a good ideal to have a fire extinguisher handy. Compression fittings do not require heat. A common place that compression fittings are used is at the water shut off valves beneath your sink, or toilet.

However there are many other places that you can use them. To make up a fitting using compression fitting. Start by cutting the inlet pipe to length, using pipe cutter. Place the compression nut and compression ring over the end of the pipe as shown above higher than then insert the pipe into the compression seat. Then using 2 wrenches one the fitting and the other for the compression nut, tighten the compression nut fully. This forces the compression pipe making a water tight seal.

For more details about http://www.plumbingcenterinc.com